
What wind damage roof repair covers
A gust strong enough to pry up one tab can turn roof wind damage into a full wind damage roof repair within a single storm cycle. By morning, shingles blew off roof often sit across the lawn or caught against a fence. You might also see a strip of bare decking along a rake line, or a tile sitting out of line on a hip or ridge. A ceiling stain two or three days later is often roof leaking after windstorm damage finding its way through slowly.
Fall and early winter bring Santa Ana wind season to this part of the Inland Empire. Strong dry gusts come off the northeast and work under shingle edges on exposed tract roofs. After one of those gusts, wind lifted my shingles is usually a seal breaking. A lifted tab breaks its seal first. Wind then gets under the course sitting above it. In the next storm that whole strip peels back, and the bare deck underneath takes rain straight on.
Here is what to do in the next few minutes if wind has already torn into the roof.
- Put a bucket under any drip and move furniture or electronics out from under it.
- Photograph the damage inside the house before anything is moved or covered.
- Stay off the roof, since a storm damaged deck in gusty wind is not a safe place to stand.
Call once you see a run of shingles missing, a ridge or hip tile out of line, or a ceiling stain that showed up right after a windy night. Waiting through one more gust lets a small tear turn into an open deck, and that is the point to call. An active leak during the storm itself, rather than loosened material alone, is a storm damage roof situation and needs attention before the next system moves in.
The CSLB License Lookup publishes the rules that govern work like this in your area.


How we handle a wind damage roof repair visit
We start on the courses that took the wind first, meaning the rakes, hips and ridge line where uplift runs highest. Each lifted tab gets a shingle flexibility and granule check, bending the edge and watching what comes off in your hand. A tab that still flexes without cracking and holds its granules gets handled as a loose shingle repair, resealed or swapped in place. A tab that cracks when lifted and sheds granules means that section of asphalt has aged past a patch, and the repair moves to replacement instead.
When the opening is small and the decking underneath reads dry, that work often becomes a same-day roof repair rather than a multi-day tear off. Where decking came up wet or is holding water, we open it, show you the board, and close that section before moving on. On an open deck overnight, roof tarping after wind keeps rain out until shingles go back on.
Replacing wind torn shingles on a full slope usually comes down to a choice between three tab and an architectural laminated shingle. The laminated product glues two layers together, so it carries more weight per square and a published wind rating commonly in the 110 to 130 mph range, though that figure only holds with the nailing pattern and starter strip the manufacturer specifies. Three tab is lighter and loses that same hold sooner on an exposed rake.
If the trouble turns out to need emergency roof repair, that page explains how the job is done.
Our crews work to the installation standards of the National Roofing Contractors Association.
Before any part gets replaced, ask to see each of these readings.
| Instrument | Good reading | Bad reading | What it changes |
|---|---|---|---|
| Shingle flexibility and granule check | A tab lifts slightly at the corner and the granules stay put | The tab cracks when it is lifted and granules come off in your hand | The asphalt has aged out |
| Ponding check on a low slope roof | The surface is dry and the drains are clear within about two days of rain | Standing water still sitting two days after rain | Loads the deck and works at every seam |
| Infrared scan of a low slope roof after sunset | The field cools evenly as the sun goes off it | Warm patches that hold heat after dark | Wet insulation stores heat that dry insulation has already given up |
How the wind damage visit runs

Walking the damage
We walk the rakes, hips and ridge first, since that is where uplift runs highest in a gust. Each lifted tab gets the shingle flexibility and granule check, and any stain inside gets traced back to a penetration or valley before we touch the roof. You see which courses took the hit and which readings came back bad. By the time we are done, the cause is named and a written quote is in your hands.
Repair or replacement
Once you approve the quote, the damaged course gets isolated first, meaning the surrounding shingles are lifted and set aside before anything comes off for good. A sound tab gets resealed in place. A cracked, granule shedding section gets cut out and replaced with matching material, along with any flashing or boot the job called for. Work pauses at that point so you can see the opened area before the new material goes down.
Checking the deck is dry
A pin moisture meter checks the decking's underside from inside the attic before we finish the repair. A reading under 15 percent means that section is dry and ready to close. A reading above that means the deck stays open until it dries or that board gets replaced. We show you the reading and the deck before the new shingles or tile go back on.
What a wind damaged roof needs in Ontario
Repairing a wind damaged roof here usually means matching the field around the torn section, not just patching the hole. Replacing a full shingle slope generally calls for a permit per the California Residential Code. The City of Ontario Building Department signs off before work begins. A small tab reseal or a single tile reset rarely rises to that same review.
Two shortcuts cause trouble on this job locally. Nailing a lifted tab back down without checking the underlayment beneath it can hide a membrane that already failed, since 1980s and 1990s tile roofs in this area are reaching the end of that underlayment's service life. The lifted tab reseals, and the next gust tears the same spot out along with the patch.
Resealing one tab on an older composition roof without walking the full course it sits on leaves the rest of that run exposed. Wind rarely lifts just one shingle. It finds every tab on that course with a weak seal, and the next storm takes the whole strip rather than the one spot that got fixed.
For background, see our guide on signs you need a new roof.
What the call and the visit cover
Today or a scheduled fix
On the call we ask what you can see from the ground and whether any water is coming through a ceiling right now. An actively spreading ring or drip calls for a technician to visit that same day. Missing shingles with no active leak and dry weather ahead can often wait for a scheduled visit instead, which gives us daylight and a calm roof to work on.
What the visit disturbs
Expect ladder access along one side of the house and a tarp or drop cloth under the work area to catch old material. If the attic shows staining, we go up through the attic hatch to look at the underside of the deck. Clear a path to that hatch and move anything stored directly under the affected slope so torn off material has somewhere clean to land.
What decides repair or replace
The biggest factor is whether the flashing, boots and ventilation around the damaged area get replaced with the repair or reused as they are. Reusing sound flashing keeps the job smaller. Replacing it, or opening more of the slope to reach it, moves the job toward a fuller repair. Once that work is scheduled, you receive the written quote and give approval before crews remove anything from the roof.
What you see before work starts
We show you the lifted tab or cracked tile where it sits, point out the granule loss or the mortar failure, and lay out the repair or replacement options in plain terms. Nothing gets opened further, and no flashing or boot gets swapped, until you say go ahead. Any decking we pull out gets set aside so you can see it before it goes in the trailer.
Wind Damage Roof Repair Questions From Ontario Homeowners
A shingle rated for 110 to 130 mph can still fail at lower gusts once its seal has aged or cracked. That rating only holds when the nailing pattern and starter strip match the manufacturer's spec, so an older or poorly fastened roof loses its hold well below that number. A single lifted tab is often the first sign, since the seal along that course has already broken. The shingle flexibility and granule check during a visit shows whether the material is still sound or has aged past the point where a patch will hold.
Put a bucket under any drip and move furniture or electronics out from under it right away. Stay off the roof, since a storm damaged deck is not a safe place to stand in gusty wind. Note which side of the house the missing shingles came from and whether water is actively coming through a ceiling. Call once you see a run of shingles gone or a stain that showed up right after a windy night, so the open deck does not take another storm.
Protect the inside of the house first with a bucket under any drip and by clearing furniture from under the leak. Photograph what you can see before anything is moved. Stay off the roof, since a torn course leaves the decking underneath exposed and unsafe to walk. Note the rough age of the roof, when the wind hit, and which side of the house lost material, since that gets a crew to the right spot faster. Call once shingles are missing or a stain appears, rather than waiting through another gust.
No single speed damages every roof, since a sound seal and a weak one fail at different points. A tab that still flexes and holds its granules can often ride out gusts near a shingle's rated range, while a cracked or granule shedding tab can tear loose well below that. Three tab shingles lose their hold on an exposed rake sooner than a laminated shingle built from two glued layers, which carries a published wind rating near 110 to 130 mph when installed to the manufacturer's nailing pattern and starter strip.
Granules collecting at the downspout usually mean the asphalt on the roof has aged and is shedding its surface coating. A tab that sheds granules when lifted has aged past the point where a reseal will hold, and that section is heading toward replacement rather than a patch. It does not by itself mean wind tore anything loose, but it does mean the material in that area is weaker going into the next gust. The shingle flexibility and granule check on site confirms whether that course needs full replacement.
Flashing comes loose because wind that lifts a shingle edge also works at the metal tucked under or over it along that same course. Once a tab's seal breaks, the gap lets wind get under the flashing's edge too, and repeated gusts walk the fasteners loose the same way they peel back shingles. Flashing around valleys, penetrations, and the rake edge sits right where uplift runs highest in a storm. Checking whether flashing can be reused sound or needs replacement is part of what decides how far the repair opens.
Tile repair centers on the mortar bed or clip holding each piece, while shingle repair centers on the seal and the asphalt itself. A shingle tab instead gets the flexibility and granule check, since cracking and granule loss tell us whether the asphalt is still sound. Both checks decide whether the fix is a reset or a full section replacement.
East and north facing edges catch Santa Ana gusts moving off the northeast first. That direct hit lets wind get under the tab instead of sliding across it, since the gust strikes the course head on. Open, low walled streets with little tree cover let that wind reach the roofline at full strength. That is why rakes, hips, and ridge lines on the exposed side get walked first during a visit.
Why Ontario Ranch tract roofs take wind damage differently
This neighborhood was built from the late 2000s to the present, and most of those roofs sit on plywood or OSB decking under either concrete tile or composition shingle. That deck type holds a nail well when it is dry, but it also telegraphs every gust straight through to the fastener. Open, low walled streets across this part of the city give wind a clean run at the roof line with little tree cover to slow it down.
A full slope reroof in this city gets inspected at the decking stage, after the old material comes off and before new underlayment goes down. That inspection looks at whether the exposed boards are sound or need to be swapped before anything goes back over them. That is one reason a repair quote on an older roof sometimes grows once the tear out starts, since a soft or delaminated board under one torn course often was not visible until the shingles came up.
Wind Damage Roof Repair Across Ontario and Nearby Towns
Besides Ontario itself, we do wind damage roof repair in the towns below.
Roofing Services Near Ontario
Need wind damage roof repair in Ontario? We cover the city and the nearby towns on the map. Call (909) 330-4661 to check your address.
Address:
Ontario Roofing, 4335 E Lowell St, Suite G
More Emergency Roofing Services in Ontario
Walking the slope to press a lifted tab back down is roofing work. A pitched surface in gusty wind throws off your balance fast, and a tab pressed down without a fresh seal lifts again in the next gust anyway. Spotting the damage from the ground and calling it in is where your part of this ends.
Know roughly how old the roof is and when the wind struck. Note what changed right after that, and point out which side of the house took the hit. If you noticed a ceiling stain, know roughly where it sits under the roof line. That gets us to the right spot faster once we arrive.
